Control Modes
Control modes decide how your command(s) control Outputs after you press Start.
Choose the control mode from a drop down on the top left of the Control tab.
If you have one Command
Direct mode
Direct mode lets you control an output of your choice.
To use direct mode:
Select direct mode
Tap Start
A single enable button appears on each output
Tap enable of the output you wish to control
The name of the command appears at the top of the output.
Use your command
The output activates
One Switch Scan
One Switch Scan automatically enables outputs, one at a time.
To use one switch scan:
Select one switch scan
Press Start
When the output you want is enabled, use your command to activate it.
If you have two Commands
Direct mode
Direct mode lets you control an output of your choice with the command of your choice
To use direct mode:
Select direct mode
Tap Start
Each output has two enables, one for each command
Tap the enable button corresponding to the command
The name of the command appears at the top of the output.
Use one of your commands
Outputs enabled for that command will activate
One Switch Scan
See One Switch Scan section above.
See Control settings to adjust which command is used when scanning.
Two Switch Scan
Two Switch Scan uses two commands to enable and activate an output:
Move Command
To move to the next output and enable it
The strength of this command appears in a blue bar at the bottom of the screen
Select Command
Activates the enabled output
The strength of this command appears on the output itself